|
1. Cut the ribbon to the
desired wrist length. Attach one crimp end with the 6mm Jump Ring a shown.
2.Thread all the crimp
beads and spread evenly on the ribbon. I used two on each side of the charms
to keep them from sliding around much. Using the needle nose pliers, flatten
the crimp beads in place.
3.Using seven of the
headpins, thread one pearl on each and using the round nose pliers, create
an eye.
4. Three of the headpins,
thread one 3mm silver bead, one pearl, and another 3mm silver bead. Create a
loop with the round nose pliers at the end.
5. Using the pliers,
attach these head pins with the 4mm jump rings throughout the bracelet.
6. Attach the charms.
7. For earrings - thread a
3mm silver bead, a pearl, and another silver bead on the eye pins. Create a
loop with the round nose pliers.
8. Remove the jump ring on
the ballet slipper charms and attach directly to the eye pins.
9. Attach the French hooks
to the other end. (Earring posts also work).
|
